Tag Archives: Health & Safety

2.4: Health and Safety

Standard

Health and Safety

This is one of the things I tend to forget to include, although I do bear it mind while I’m working.Burning my finger on the soldering iron has prompted me to write something out for Module 2, Chapter 4, and rather than adding it to the main post, I’ve done a separate post (which is a little garbled), just to show I do think about these things.

Soldering Iron

DSCN7940 (2)

The soldering iron, in its pot, ready for  burnt plastic, burnt acetate and burnt finger to be cleaned from the tip!

I was trying to see if I could use the soldering iron to cut a stencil on an acetate sheet, using a plastic letter as a template, and the wooden bread board as a base to work on – none of which was a good idea. Luckily, the finger isn’t badly burned – I caught it, because I wasn’t paying attention, but it’s painful, and it’s the forefinger on the right hand, and I’m right-handed which makes it awkward to do things. And I’ve got nothing to show for my efforts, because I melted the side of the plastic letter, and the acetate melted unevenly but didn’t burn all the way through (and it smelled awful). And I’ve got burn marks on the bread board. All I can say in my favour is that I always rest the soldering iron through the hole of a big earthenware plant pot, and I don’t have trailing wires. But I shall be a lot more careful in future, and will invest in some kind of safer surface to work on, and remember to work in a well ventilated space, and to keep my fingers well away from the hot metal bits.

Cutting Metal

The aluminium cider can I cut the pen nibs from is easy to cut with an old pair of scissors, and the edges aren’t really sharp, but I usually wear gardening gloves to protect my hands. And after the incident with the soldering iron, I might start sanding the edges (with the gloves on) just to be on the safe side. The main issue is little bits of metal flying all over the place if you keep trimming it to get the right shape and size. In an ideal world I guess one should wear protective goggles, but glasses seem to offer some protection to your eyes – I wear my spare pair, so there’s no risk of damaging the decent ones.

Cutting with a Craft Knife

I’m not very good at this, but I use a self-healing cutting mat, and a cut against the edge of a thick plastic patchwork measure. And try to remember to cut away from me, and use the cover on the knife when it’s not in use.

Sewing Machine

Normally I use this in the spare room, and the desk it’s on is right next to the switch, and the wires are neatly tucked away between the desk and a book shelf. I never put drinks there, for fear of knocking them over, and if I’m changing needles, or putting a different foot on, or something like that, I usually switch off, or check that my foot is nowhere near the pedal!

My Little Shed (aka The Glory Hole)

DSCN7108This is where I store arty-crafty things and do quite a bit of work. It does get very messy (it’s very small and I’m not very tidy) but I do my best to put things away, to reduce the chance of spillages, breakages, accidents etc (I’ve got lots of drawers and some shelving). It does have electricity, and I’m very careful not to have trailing wires, and to ensure that anything electrical is switched off each time I leave, and I make sure I don’t leave drinks or water for painting on the side where the plug is (when I was working I once spilled fizzy pop over a computer keyboard, with disastrous consequences, and ever since then I’ve been wary of drinks near electrical stuff).

DSCN7109

A plastic drawer unit supporting the work surface – there’s another one at the other end.

The work surface is under the window, so there’s plenty of good natural light, but I’ve got one of those spot-light type lamps that I can swivel around to get the light where I want, if I need it. The work surface (a board across the top of two plastic drawer units for storage) is exactly the right height for me (but too low for most people I expect) so I don’t get back ache or anything. And the chair is an old folding wooden garden chair, which is also exactly the right height for someone who is five foot nothing, and just perfect with the work surface. If I’m doing anything that could involve fumes I can work with the door open (wide open when it’s sunny, and wedged ajar with a brick when it’s cold and wet!).I keep plenty of baby wipes and kitchen roll for mopping up and cleaning things.

I don’t have to worry about children or animals, and anything hazardous is labelled (but some jars of made-up Brusho ink and Procion dyes are not labelled, and I have no idea which is which, and the liquids look remarkably similar).

I’m very lucky, because my husband made the shed for me a couple of years ago, and he even insulated it, and put the tiniest electric oil radiator in there for mega-icy winter weather! Then, when I showed Mum some photos she was so impressed she gave me cash to buy storage containers to replace the ill-matched assortment of cardboard boxes I had been using.